Page 1 of 1

DWG Export function

Posted: Wed Jun 06, 2018 7:06 am
by Stefano.Vegnuti
Good morning everyone,
I'm having anissue with the .dwg export function in Dialux EVO.
It turns out that when I export a 2D drawing, luminaires are of course exported as 2D blocks, but nonetheless they retain their geometrical complexity.
(see image attached)

This makes it sometimes almost impossible to handle even a small .dwg file.
I was wondering whether it was somehow possible to export just a simplified item (for instance, a rectangule for a linear pendant...)

Thanks!

Re: DWG Export function

Posted: Thu Jun 07, 2018 8:01 am
by T.Magenheimer
Dear Stefano.Vegnuti,

Currently this is not possible in our evo software, but we will add this point to our roadmap which is the basis for the development of the next evo versions.


Best regards,
DIAL Support Team