Hi,
How caan I increase uniformity of Vertical illuminance ?
In case of horizontal illuminance,when uniformity is less,I simply add a luminaire at the place where illuminance numbers are less.
But that is not possible for uniformity of Vertical illuminance.
Please help.
Thanks,
Gaurav
Vertical illuminance uniformity
Re: Vertical illuminance uniformity
Hi Gaurav,
You must increase the minimum value of the illuminance calculated on the calculation surface in order to increase the uniformity (min/average).
Best regards,
DIAL Support Team
You must increase the minimum value of the illuminance calculated on the calculation surface in order to increase the uniformity (min/average).
Best regards,
DIAL Support Team
-
- Posts: 14
- Joined: Sat Feb 09, 2019 7:09 pm
Re: Vertical illuminance uniformity
Yes I can do that.
But,how can I do it for vertical illuminance?
As the luminaire is same and has no relation with horizontal and vertical illuminance.
I have sent my file on ur email ID..Can you check it?
Thanks,
But,how can I do it for vertical illuminance?
As the luminaire is same and has no relation with horizontal and vertical illuminance.
I have sent my file on ur email ID..Can you check it?
Thanks,
Re: Vertical illuminance uniformity
Hi Gaurav,
So far we have not received any email from you.
Best regards,
DIAL Support Team
So far we have not received any email from you.
Best regards,
DIAL Support Team
-
- Posts: 14
- Joined: Sat Feb 09, 2019 7:09 pm
Re: Vertical illuminance uniformity
Hi there,
I have a doubt again!
In the project manager window,in the calculation tab, what should be the angle in degrees for calculating vertical illuminance?and what should be the height?
Thanks,
Gaurav
I have a doubt again!
In the project manager window,in the calculation tab, what should be the angle in degrees for calculating vertical illuminance?and what should be the height?
Thanks,
Gaurav
Re: Vertical illuminance uniformity
Hi Gaurav,
We cannot answer this question. The parameters depend on how your lighting design is to be made.
Best regards,
DIAL Support Team
We cannot answer this question. The parameters depend on how your lighting design is to be made.
Best regards,
DIAL Support Team
Who is online
Users browsing this forum: No registered users and 3 guests