Hello,
I'm calculating for a soccer field. The GR has to be below 50. To be sure I meet the requirements, I now put over the soccer field GR observers in a grid of 10 by 10 meters. When done so I have to check the output and check every line for the result.
Is there an other way to do this? For instance a measurement layer which gives the results just like the average with ISO lines but than with the ISO lines for the GR values?
Regards,
John
Glare ratio calculation
Re: Glare ratio calculation
Dear John,
If you would like to get a grid of GR observers, then there is no other possibility as to insert several GR observer points to the required positions.
Best regards,
DIAL Support Team
If you would like to get a grid of GR observers, then there is no other possibility as to insert several GR observer points to the required positions.
Best regards,
DIAL Support Team
Who is online
Users browsing this forum: No registered users and 1 guest