Two levels of ceiling

Posts: 1
Joined: Thu Nov 21, 2013 9:07 am

Two levels of ceiling

Post by jsagem » Thu Nov 21, 2013 11:47 am

Hallo everyody!

I would like just to ask how is t possible to create in a room two levels of ceiling.
I have one application where the room has a ceiling of 3,2 m in its most part and one piece is on 5m.
Reight now the solution I have found is to have the whole room on 5m and then use flat ceiling modules for the 3,2. the problem is that the solution ist most time consuming and the second that the flat ceilings are only rectangular modules.

Is there a way to have the whole ceiling on 3,2 and then enlarge the point of interest on 5m?

Posts: 317
Joined: Mon Sep 24, 2012 9:59 am

Re: Two levels of ceiling

Post by M.Holthaus » Fri Nov 22, 2013 12:56 pm

Hello jsagem,

Unfortunately, it is not possible in DIALux 4 to have different heigths of the room.
To reduce the height you have to use e.g an extrusion volume to create a individual object.

Kind regards,
Maurice Holthaus


Who is online

Users browsing this forum: No registered users and 2 guests