Page 1 of 1

Perimeter area

Posted: Fri Sep 11, 2020 9:08 am
by Angepaba
I would like to ask if there is a way to know the Workplane area without the Wall Zone.
I mean, in the report you can find the "Ground area" (Room) but I need to know the area when removes this perimeter area (Workplane).
001.jpg (33.04 KiB) Viewed 1160 times
Theank you.

Re: Perimeter area

Posted: Wed Sep 16, 2020 11:35 am
by T.Magenheimer
Hello Angepaba,

If you have not constructed a wall zone in your room, only the "Room" is output in the output for the lighting power density.

As soon as you have constructed a wall zone, the "Workplane" is output in addition to the "Room". The output of the "Workplane" thus takes the wall zone into account.

Best regards
Your DIAL Support Team