Page 1 of 1

Exterior Calculation

Posted: Thu Feb 14, 2019 4:43 pm
by 64_Richard
Hi,
I have an exterior lighting project that has various separate areas that need calculation.
I've set up several assessment zones, but I can't isolate them, to run a calculation on that area only.
How can I do this?
Every time I need to move or change a luminaire in one space, I seem to have to recalculate the complete project...which takes a long while.
Also is there a way to run a calculation just to see how the lighting looks? I'm not too worried about levels at this point.
Thank you.

Re: Exterior Calculation

Posted: Tue Feb 19, 2019 7:33 am
by Csuleiman
Hi 64_Richard,

Unfortunately it is not possible to calculate each assessment zone separately in the site.
In the "Display options" you can have the lighting effect of selected luminaires displayed by means of "Show light visualisation".

2.JPG
2.JPG (45.94 KiB) Viewed 1624 times

Best regards,
DIAL Support Team

Re: Exterior Calculation

Posted: Wed Feb 20, 2019 10:41 am
by 64_Richard
I seem to still have to run a complete project calculation for that to work.